- Tajima dgml by pulse embroidery software sidekick windows 7#
- Tajima dgml by pulse embroidery software sidekick windows#
A red processing box should open and then close immediately if there is connection.įor TMAR-K and TMEZ, turn the machine off and then back on, check P7 Network options and verify that Network is set to DGML Return to 10 Networking and turn the gray dial to set the option to Normal ( alternate options, Yes or DG/ML ). Arrow down to 10 Networking, turn the gray dial to set the option to No, press SET. On MX models hold SET and press F3 at the same time for the SET+F3 menu. If there are no machines available, refresh the network connection on the embroidery machine. Give the spooler a few moments to start up and run and then check this setting again. If this option is grayed out and you cannot change it, that is an indication that the design spooler is not running, close the settings window, start the design spooler. LAN Machine Support - this option should be ENABLED - if this is DISABLED no machines can connect. The Multiple queue allows the selection of a single machine when sending and retrieving designs Queue Type - typically, this is set to Multiple - the Single queue option allows all connected machines to access all designs sent through the LAN, Any Machine. You will find these settings under Tools/Spooler Settings ***ĭesign Spooler Location - for the spooler computer this should be set to Always use the spooler running on the local computerĭesign Spooler Host - with the Local spooler setting, this will automatically be set to localhose:9050 *** Also, check the Design Spooler settings in the software for changes.
Tajima dgml by pulse embroidery software sidekick windows#
Windows 10, click the windows start button, scroll to Tajima, click to open the folder for the start/stop design spooler optionsĬlick Stop and then Click Start - wait a few moments for the design spooler to get up and running and check for the machine(s) in the output to machine window.
Tajima dgml by pulse embroidery software sidekick windows 7#
Windows 7 click the windows start button/all programs/Tajima/DG# by Pulse, click to open the folder for the start/stop design spooler options.
You will find the start and stop icons as follows: Please check your design spooler and be sure it is running, stopping and restarting the design spooler may correct your issue. incorrect LAN enabled designation for multiple Sec.Ethernet Cable Disconnected from machine.Here are troubleshooting steps to help get your connections back. Occasionally, machine connection to the design spooler may fail, there are many factors that affect this issue.